Seachem Saltwater

Information

Manufacturers

New products

Seachem Reef Builder 300g View larger

Seachem Reef Builder 300g

SC-020505

New product

Raises carbonate alkalinity (KH) with minimal impact on pH

More details

£ 9.99

Add to wishlist

More info

Seachem Reef Builder

  • Raises carbonate alkalinity (KH) with minimal impact on pH
  • A blend of carbonate sources that will not lower pH as competing bicarbonate only products can
  • Will not deplete calcium, magnesium, or strontium

Reef Builder™ raises carbonate alkalinity (KH) without immediately impacting on pH. With long term use there will be a tendency to stabilize at pH 8.3. Used as directed, Reef Builder™ will not deplete calcium, magnesium, or strontium which usually tend to precipitate with increasing alkalinity. Reef Builder™ and Reef Buffer™ may be used together. Use Reef Builder™ to raise carbonate alkalinity without affecting pH. Use Reef Buffer™ to raise carbonate alkalinity and pH. Reef alkalinity should be maintained at 3–5 meq/L (8–14 dKH). Alkalinity should not be allowed to fall below 2 meq/L.

Directions

Beginner

Use 3 g (1/2 level teaspoon) per 150 L (40 US gallons) twice a week. Dissolve in at least 250 mL (1 cup) of freshwater. Check alkalinity every 2 weeks and adjust amount or frequency accordingly. For precise dosing, use the Seachem Digital Spoon Scale.

Advanced

Check alkalinity (use MultiTest™ Marine pH & Alkalinity to test alkalinity levels), then follow addition regimen above until alkalinity is adjusted to 3-6 meq/L (8-17 dKH). Each 3 g/150 L will raise alkalinity by about 0.25 meq/L. Quantity or frequency can be adjusted, but do not exceed 12 g/150 L per day. Thereafter, use as required to maintain alkalinity.

Expert

After determining the alkalinity consumption rate, set up a continuous drip system. Use the following formula (or skip the math and use our Dosage Calculator) to determine how much to add to your top–off water: m=0.08va (m=grams to add to top off water, v=volume of tank in liters, a=amount to raise alkalinity in meq/L). For example, if you want to raise your alkalinity by 1 meq/L in a 200 liter tank, then you would add 0.08x200x1=16 g into the top–off water. [For reference: 1 gallon=3.8 liters, 6 g=1 teaspoon].

Trusted Shops Reviews

Accessories